九鼎创展论坛

标题: 重新烧写一下内核镜像（通过fastboot）,结果开发板启动不了了 [打印本页]

作者: 云开见月明 时间: 2015-10-21 17:58
标题: 重新烧写一下内核镜像（通过fastboot）,结果开发板启动不了了
x210开发板：重新烧写一下内核镜像（通过fastboot）,结果开发板启动不了了，启动信息是这样：
U-Boot 1.3.4-dirty (Oct 19 2015 - 15:30:16) for x210

CPU:  S5PV210@1000MHz(OK)
      APLL = 1000MHz, HclkMsys = 200MHz, PclkMsys = 100MHz
      MPLL = 667MHz, EPLL = 96MHz
                     HclkDsys = 166MHz, PclkDsys = 83MHz
                     HclkPsys = 133MHz, PclkPsys = 66MHz
                     SCLKA2M  = 200MHz
Serial = CLKUART
Board: X210
DRAM: 512 MB
Flash: 8 MB
SD/MMC:  3776MB
In:    serial
Out:    serial
Err:    serial
[LEFT DOWN] update mode
fdisk is completed

partion # size(MB)    block start # block count partition_Id
1          258          22671       528990       0x83
2          258          551661       528990       0x83
3          103       1080651       211596       0x83
4       3132       1292247       6415893       0x83
sdmmc init is failed.
[Fusing Image from SD Card.]
[Partition table on MoviNAND]
ptn 0 name='bootloader' start=0x0 len=N/A (use hard-coded info. (cmd: movi))
ptn 1 name='kernel' start=N/A len=N/A (use hard-coded info. (cmd: movi))
ptn 2 name='ramdisk' start=N/A len=0x300000(~3072KB) (use hard-coded info. (cmd: movi))
ptn 3 name='config' start=0xB11E00 len=0x1024BC00(~264495KB)
ptn 4 name='system' start=0x10D5DA00 len=0x1024BC00(~264495KB)
ptn 5 name='cache' start=0x20FA9600 len=0x6751800(~105798KB)
ptn 6 name='userdata' start=0x276FAE00 len=0xC3CC2A00(~3207946KB)
Partition: bootloader, File: /x210/uboot.bin
** Can't read from device 1 **
** Invalid partition **
checking mode for fastboot ...
Hit any key to stop autoboot:  0
reading kernel.. 1073, 8192
MMC read: dev # 0, block # 1073, count 8192 ...8192 blocks read: OK
completed
Boot with zImage

Starting kernel ...

欢迎光临九鼎创展论坛 (http://bbs.9tripod.com/)