九鼎创展论坛

标题: x210启动打印信息 [打印本页]

作者: terceling1234    时间: 2015-8-13 12:05
标题: x210启动打印信息
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
failed to find udc vcc source
Failed to power up USB
s5p-ohci s5p-ohci: EXYNOS OHCI Host Controller
s5p-ohci s5p-ohci: new USB bus registered, assigned bus number 2
s5p-ohci s5p-ohci: irq 87, io mem 0xec300000
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 1 port detected
usbcore: registered new interface driver cdc_acm
cdc_acm: USB Abstract Control Model driver for USB modems and ISDN adapters
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
usbcore: registered new interface driver usbserial
USB Serial support registered for generic
usbcore: registered new interface driver usbserial_generic
usbserial: USB Serial Driver core
USB Serial support registered for GSM modem (1-port)
usbcore: registered new interface driver option
option: v0.7.2:USB Driver for GSM modems
s3c-udc : S3C HS USB Device Controller Driver, (c) 2008-2009 Samsung Electronics
s3c-udc : version 15 March 2009 (DMA Mode)
g_ether gadget: using random self ethernet address
g_ether gadget: using random host ethernet address
usb0: MAC fe:ca:06:d9:27:c3
usb0: HOST MAC 9e:23:aa:c4:d4:42
g_ether gadget: Ethernet Gadget, version: Memorial Day 2008
g_ether gadget: g_ether ready
failed to find udc vcc source
Failed to power up USB
Registered gadget driver 'g_ether'
mousedev: PS/2 mouse device common for all mice
cal_x_max=800,cal_y_max=480

samsung-ts s3c64xx-ts: driver attached, registering input device
input: s3c_ts as /devices/virtual/input/input2
Initial ft5x06 Touch Driver
input: ft5x06-ts as /devices/virtual/input/input3
usb 1-1: new high speed USB device number 2 using s5p-ehci
[FTS] Firmware version = 0x22
[FTS] report rate is 60Hz.
[FTS] touch threshold is 108.
i2c-core: driver [ft5x06-iic] using legacy suspend method
i2c-core: driver [ft5x06-iic] using legacy resume method
i2c /dev entries driver
lirc_dev: IR Remote Control driver registered, major 253
IR NEC protocol handler initialized
IR RC5(x) protocol handler initialized
IR RC6 protocol handler initialized
IR JVC protocol handler initialized
IR Sony protocol handler initialized
IR RC5 (streamzap) protocol handler initialized
IR LIRC bridge handler initialized
Linux video capture interface: v2.00
hub 1-1:1.0: USB hub found
mfc_init: <6>S5PC110 MFC Driver, (c) 2009 Samsung Electronics

hub 1-1:1.0: 4 ports detected
S3C JPEG Driver, (c) 2007 Samsung Electronics
JPEG driver for S5PV210
i2c i2c-1: attached s5p_ddc into i2c adapter successfully
S5PC11X HPD Driver, (c) 2010 Samsung Electronics
S5PC11X CEC Driver, (c) 2010 Samsung Electronics
S3C2410 Watchdog Timer, (c) 2004 Simtec Electronics
s3c2410-wdt s3c2410-wdt: watchdog inactive, reset disabled, irq enabled
usbcore: registered new interface driver usbhid
usbhid: USB HID core driver
logger: created 256K log 'log_main'
logger: created 256K log 'log_events'
logger: created 256K log 'log_radio'
logger: created 256K log 'log_system'
Error: Driver 'samsung-audio' is already registered, aborting...
wm8978 probe

wm8978 2-001a: Failed to add route Right Capture PGA->Right Boost Mixer
asoc: wm8978_codec <-> samsung-i2s.0 mapping ok
asoc: wm8978_codec <-> samsung-i2s.0 mapping ok
ALSA device list:
  #0: smdk
Netfilter messages via NETLINK v0.30.
NF_TPROXY: Transparent proxy support initialized, version 4.1.0
NF_TPROXY: Copyright (c) 2006-2007 BalaBit IT Ltd.
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP cubic registered
NET: Registered protocol family 10
ip6_tables: (C) 2000-2006 Netfilter Core Team
IPv6 over IPv4 tunneling driver
NET: Registered protocol family 17
NET: Registered protocol family 15
lib80211: common routines for IEEE802.11 drivers
VFP support v0.3: implementor 41 architecture 3 part 30 variant c rev 2
regulator_init_complete: pd_cam_supply: incomplete constraints, leaving on
regulator_init_complete: pd_mfc_supply: incomplete constraints, leaving on
regulator_init_complete: pd_tv_supply: incomplete constraints, leaving on
FIMC0 registered successfully
FIMC1 registered successfully
FIMC2 registered successfully
S5PC1XX TVOUT Driver, (c) 2009 Samsung Electronics
s5p-tvout s5p-tvout: hpd status is cable inserted
Warning: unable to open an initial console.
Freeing init memory: 824K
init (1): /proc/1/oom_adj is deprecated, please use /proc/1/oom_score_adj instead.
init: cannot open '/initlogo.rle'
init: cannot find '/system/busybox/bin/sh', disabling 'check_property'
init: cannot find '/system/bin/servicemanager', disabling 'servicemanager'
init: cannot find '/system/bin/vold', disabling 'vold'
init: cannot find '/system/vendor/bin/pvrsrvinit', disabling 'pvrsrvinit'
init: cannot find '/system/bin/netd', disabling 'netd'
init: cannot find '/system/bin/debuggerd', disabling 'debuggerd'
init: cannot find '/system/bin/rild', disabling 'ril-daemon'
init: cannot find '/system/bin/surfaceflinger', disabling 'surfaceflinger'
init: cannot find '/system/bin/app_process', disabling 'zygote'
init: cannot find '/system/bin/drmserver', disabling 'drm'
init: cannot find '/system/bin/mediaserver', disabling 'media'
mfc_firmware_request_complete_handler: failed to load MFC F/W, MFC will not working
init: cannot find '/system/bin/dbus-daemon', disabling 'dbus'
init: cannot find '/system/bin/installd', disabling 'installd'
init: cannot find '/system/etc/install-recovery.sh', disabling 'flash_recovery'
init: cannot find '/system/bin/keystore', disabling 'keystore'
init: cannot find '/system/busybox/bin/sh', disabling 'usb_dongle_cfg'
init: property (null) has no value for writing to /sys/class/android_usb/android0/iManufacturer
init: property (null) has no value for writing to /sys/class/android_usb/android0/iProduct
init: cannot find '/system/busybox/bin/ash', disabling 'console'
作者: armeasy    时间: 2015-8-13 13:35
你这个是没有发现文件系统,要么没烧system.img,要么 uboot环境变量有问题
作者: terceling1234    时间: 2015-8-13 13:43
fastboot flash bootloader C:\android\uboot.bin
fastboot flash kernel C:\android\zImage-android
fastboot flash system C:\android\x210.img
作者: armeasy    时间: 2015-8-13 13:47
烧的正确,看下uboot环境变量




欢迎光临 九鼎创展论坛 (http://bbs.9tripod.com/) Powered by Discuz! X3.2